Dyno ASM is the dedicated dynamometer for under load emission measurements in accordance with BAR 97 Specification, ruling the standards required for the evaluation of vehicle emissions with particular reference to ASM 5015/2525. Dyno ASM allows to perform a number of emission measurements in different load conditions, such as constant or variable load in the simulation of driving cycles; a wider range of settings are available for further measurements on all kinds of passenger cars.

The DF2ASM can be installed either above floor or embedded and supports both petrol and diesel vehicles.

Software features

  • Road simulation mode according to Acceleration Simulation Mode specification (ASM-5015 and ASM-2525)
  • Road simulation for transient emission testing
  • Coast down mode to calculate the PLHP value (Parasitic Loss Horsepower)
  • Constant speed mode
  • Constant torque mode
  • Measurement of the power available at the wheel

Chassis Dynamometer features

  • Four roller set with belts link
  • Eddy current brake 1200 N*m
  • Integrated flywheel
  • Integrated electric engine
  • Pneumatic lifting system
  • Integrated weight measurement system (Optional)
  • Ramps (Optional)
  • Powder coated chassis and rollers
  • Galvanized top covers
  • Vehicle restraint system

All the above features comply with BAR97 and EPA 420 specifications

DYNO ASM TECHNICAL SPECIFICATIONS
Nominal voltage 400 +/- 10%
Nominal current 16 A
Frequency 50/60 Hz
Magnetic protection 16 A
Axle load 2722 kg (6000 lbs)
Test stand weight 980 kg (2161 lbs)
roller set
Test speed max 193 km/h (120 mph)
Roller set length 3620 mm (142.5 inch)
Roller set width 718 mm (28.3 inch)
Roller set height 315 mm (12.4 inch)
Roller set diameter 217 mm (8.56 inch)
Roller axle center separation 439 mm (17.3 inch)
Roller length 850 mm (33.5 inch)
Interior track width vehicle 762 mm (30 inch)
Exterior track width vehicle 2540 mm (100 inch)
Roller surface Powdered coated
Driving direction Bi-directional
Operating temperature 1.7°C to 43.3°C (35°F to 110°F)
LIFT BEAM
Operation Pneumatic
Compressed air ca. 6-8 bar (87-116 psi) max. 10 bar (145 psi)
eddy-current brake with flywheel
Type FRENELSA F 16-120
Number of coils 16
Max. current 10 A
Voltage 192 V
Range of flywheel mass (traction mode) 907 kg - 2722 kg (2000 lbs - 6000 lbs)
Mechanical flywheel mass (static) 907 kg +/- 18 kg (2000 lbs +/- 40 lbs)
Width of brake 390 mm (15.4 inch)
Height of brake 295 mm (11.6 inch)
Rotor inertia 0,5 kg/m2
DRIVE
Three phase motor 400 V - 50/60 Hz
Power 3 kW
Speed Max 55 km/h (33 mph)
WEIGHING SYSTEM
Sensor (optional) Integrated in the lift beam
Weighing range 363 kg - 2722 kg (800 lbs - 6000 lbs)
Accuracy +/- 45 kg (+/- 100 lbs)

Loading